TM-9-2520-215-34

CROSS-DRIVE TRANSMISSION ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 2005

TM-9-2520-215-34 - Page 305 of 508

TM 9--2520--215--34

0060 00--1

TORQUE CONVERTER LOCKUP CLUTCH ASSEMBLY AND RELATED PARTS

REPAIR

0060 00

THIS WORK PACKAGE COVERS:

Disassembly, Cleaning, Inspection, Fit and Wear Limits, Assembly

INITIAL SETUP:

Tools and Special Tools

General mechanic’s tool kit (item 1, WP 0088 00)

Compressor assembly (item 3, WP 0088 00)

Materials/Parts

Retaining ring (item 73, WP 0087 00)

Spring pin (item 93, WP 0087 00)

Gasket (item 69, WP 0087 00)

Equipment Conditions

Torque converter lockup clutch removed

(WP 0059 00)

DISASSEMBLY

1. Drive spring pin (1) into backplate (2) until flush with rear of backplate (2). Install compressor assembly and

depress backplate until pressure on snap ring (3) is relieved. Remove snap ring (3). Discard snap ring.

2. Release compression on backplate (2). Remove two compressor assembly bolts (4). Install 3/8--16 puller bolts

(with nuts) (5) through compressor bar into backplate (2). Remove backplate (2) by tightening nuts, alternating

from side to side.