TM-9-2520-215-34

CROSS-DRIVE TRANSMISSION ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 2005

TM-9-2520-215-34 - Page 309 of 508

TM 9--2520--215--34

TORQUE CONVERTER LOCKUP CLUTCH ASSEMBLY AND RELATED PARTS

REPAIR – CONTINUED

0060 00

ASSEMBLY – Continued

3. Install piston release spring (7) and clutch plate (8) into housing (9).

4. Install three locating balls (6), retaining them with oil soluble grease. Install clutch backplate (2) flat side down,

aligning three half--round slots (14) to engage three locating balls (6).

2

6

7

8

9

14

5. Install compressor assembly and compress backplate (2) until clear of snap ring groove. Install new snap ring (3),

aligning its gap with pin hole in backplate (2). Install new spring pin (1). Drive pin (1) in until pin (1) is flush with

upper surface of snap ring (3).

NOTE

FOLLOW--ON MAINTENANCE:

Install lockup clutch assembly (WP 0059 00)

END OF WORK PACKAGE

0060 00--5/6 blank