TM-9-2520-215-34

CROSS-DRIVE TRANSMISSION ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 2005

TM-9-2520-215-34 - Page 404 of 508

TM 9--2520--215--34

0075 00--2

OUTPUT PRESSURE AND BRAKE COOLANT PUMP AND OUTPUT

DRIVESHAFT REPLACEMENT – CONTINUED

0075 00

REMOVAL – Continued

2. Remove 12 bolts (4) from right bearing retainer (5). Install three bolts (4) in tapped holes (6). Using three bolts

(4) as jacking screws, remove retainer (5) and right bearing outer race as a unit.

3. Remove 12 bolts (7) from left bearing retainer (8). Remove retainer (8) and shims (9). Measure each shim with

micrometer caliper and record total shim pack thickness. Tie shims (9) together until assembly.