TM-9-2520-215-34

CROSS-DRIVE TRANSMISSION ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 2005
TM-9-2520-215-34

  TM-9-2520-215-34 - Page 394 of 508

TM 9--2520--215--34
0074 00--12
LOW AND REVERSE RANGE PLANETARIES AND RELATED PARTS REPAIR
– CONTINUED
0074 00
ASSEMBLY – Continued
6. Press spindle (26) into bore in reverse range planetary carrier (25), installing lock ball (27) when spindle pocket in
the spindle is near carrier. Press spindle (26) flush with carrier (25).
7. Repeat Steps 2 through 6, above, for installation of seven spindle and pinion assemblies.
8. Stake reverse range planetary carrier (25) against spindle (26) ends at eight to ten points approximately 1/16 inch
outside spindle bore circumference, or peen approximately 30 percent of spindle bore circumference against end
of spindles.
9. Install ball bearing (13) into bore of reverse range sun gear (14). Install new internal snap ring (24).


Back to Top