TM-9-2520-234-35
POWER TRAIN ASSEMBLY; ALLISON MODEL XTG411-2A
TECHNICAL MANUAL; FIELD AND DEPOT MAINTENANCE MANUAL
JULY 1962
TM-9-2520-234-35 - Page 184 of 323
*C2
*C2
*C2
CHAP
5,
SEC
XXV I
INTERMEDIATE PLANETARY, LOW RING GEAR REBUIL D
PAR
191-195
the planetary carrier and position the spindle
for installation. See fig. 222.
Note . Be sure that the slot on the
spindle is indexed properly with its
lock pin bore in the carrier.
i.
With
a
press
and
spindle
replacer
8351266, install planetary carrier spindle (fig.
222). The spindle replacer will bottom against
the carrier when the spindle is properly posi-
tioned in the carrier.
j . Using a hammer and punch, instal l
the planetary carrier spindle lock pin (fig.
219). Drive the pin in 0.030 to 0.060 below
the surface of the carrier. Stake metal over
the pin.
Section XXVI. INTERMEDIATE-RANGE PLANETARY AND LOW-RANG E RING GEAR — REBUILD
192. DESCRIPTIO N
Refer to pars. 12 and 13 for the descrip-
tion of the intermediate-range planetary and
low-range ring gear.
193. DISASSEMBLY (fig. 376, fold-out 5)
Note . All related items not covered
in a through d , below, were removed
from the transmission as outlined in
par. 75, steps 116, 123 and 124. No
further disassembly of these parts is
required.
a . Remove retaining ring that retains the
intermediate-range planetary carrier assem-
bly in the low-range ring gear (fig. 223). Re-
move the carrier assembly.
b . Using a hammer and punch, remove
four planetary carrier spindle lock pins (fig.
224).
c . Using a press and a piece of 3/8-inch
drill rod approximately 6 inches long, or other
suitable press tool, remove four planetary
spindles from the carrier (fig. 225).
d . Remove planetary carrier pinions,
spacers, thrust washers and bearing rollers
from the carrier (fig. 225).
15 2
194. CLEANIN G
Refer to par. 71 for cleaning recommen-
dations.
195. INSPECTION AND REPAIR
Refer to par. 72 for general inspection
Figure 223. Removing (or installing) retaining ring
that retains intermediate-range planetary carrier assembly
Back to Top
