TM-9-2520-238-34
M113A1 FOV, M113A2 FOV, M548 AND M548A1
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL; RIGHT ANGLE DRIVE, COOLING FAN; GEARCASE, TRANSFER; DRIVE ASSEMBLY, FINAL; DIFFERENTIAL, STEERING CONTROL; BRAKE, SINGLE DISK; CYLINDER ASSEMBLY, HYDRAULIC BRAKE
TM-9-2520-238-34 - Page 135 of 319
TM 9-2520-238-34
REPLACE TRANSFER GEARCASE A, B, OR C WITH SERVICE SPARE TRANSFER
GEARCASE E — Continued
0018 00
9.
Apply antiseize compound to threads of two clean cap screws (17) at installation. Install bracket (14) on housing cover
(18) with two key washers (19) and cap screws. Tighten cap screws to 144-180 lb-in (17-20 N•m) torque. Use torque
wrench (WP 0033 00, Item 41). Bend tabs on key washers.
10. Install remote control lever (20) on engine disconnect actuator (21).
NOTE
Pin must be a press-fit into remote control lever on engine disconnect actuator. If necessary,
ream the pin hole with a 5/16 inch (31 cm) drill bit. Do not ream hole larger than 0.313 inch (.6
cm).
11. Secure remote control lever (20) to actuator (21) by pressing or driving grooved pin (22) into pin hole.
0018 00-9
This is an internal gear and is not
removed here.
This is only shown
as a reference for the pump installation.
NOTE
Back to Top
