TM-9-2520-238-34

M113A1 FOV, M113A2 FOV, M548 AND M548A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL; RIGHT ANGLE DRIVE, COOLING FAN; GEARCASE, TRANSFER; DRIVE ASSEMBLY, FINAL; DIFFERENTIAL, STEERING CONTROL; BRAKE, SINGLE DISK; CYLINDER ASSEMBLY, HYDRAULIC BRAKE

TM-9-2520-238-34

  TM-9-2520-238-34 - Page 229 of 319

TM 9-2520-238-34
REPAIR DIFFERENTIAL STEERING CONTROL ASSEMBLY — Continued
0026 00
CLEANING
CLEAN, INSPECT, AND REPAIR
1.
Before inspection, repair, or assembly, clean all parts of differential steering control assembly as described in
(WP 0014 00).
2.
Inspect all parts. Refer to (WP 0014 00) for general inspection and repair procedures. Check wear limits and part
clearances on differential steering control assembly page 0026 00-12. Repair or replace defective parts.
3.
Inspect six sleeve bearings (15), sleeve bearing (16), and ring spacer (17) in differential flange (18). Remove and discard
damaged part(s). Use arbor press.
NOTE
If inspection of six expansion plugs and three straight pins indicates replacement is required, do
Step 4.
4.
Remove expansion plug(s) (19) and pin(s) (20) from differential flange (18) Discard plug(s) and pin(s).
0026 00-5


Back to Top