TM-9-2520-238-34

M113A1 FOV, M113A2 FOV, M548 AND M548A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL; RIGHT ANGLE DRIVE, COOLING FAN; GEARCASE, TRANSFER; DRIVE ASSEMBLY, FINAL; DIFFERENTIAL, STEERING CONTROL; BRAKE, SINGLE DISK; CYLINDER ASSEMBLY, HYDRAULIC BRAKE

TM-9-2520-238-34 - Page 230 of 319

TM 9-2520-238-34

REPAIR DIFFERENTIAL STEERING CONTROL ASSEMBLY — Continued

0026 00

5.

Inspect ring spacer (1), six sleeve bearings (2), and sleeve bearing (3) in differential ﬂange (4). Remove and discard

damaged part(s). Use arbor press.

NOTE

If inspection of six expansion plugs and three straight pins indicates replacement is required, do

Step 6.

6.

Remove expansion plug(s) (5) and pin(s) (6) from differential ﬂange (4). Discard plug(s) and/or pin(s).

ASSEMBLY

NOTE

If any of the three straight pins or six expansion plugs were removed from differential ﬂange in

page 0027 00-5 above, do Step 1.

1.

Install new pin(s) (6) and/or new expansion plug(s) (5) in differential ﬂange (4). Stake each pin(s) four places. Stake

each plug(s) two places.

NOTE

If sleeve bearings or ring spacer were removed from differential ﬂange in page 0026 00-5 above,

do Step 2.

2.

Install new sleeve bearing (3), sleeve bearing(s) (2), and/or ring spacer (1) in differential ﬂange (4). Use arbor press.

0026 00-6