TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 236 of 933

TM 9-2520-270-34

13. REMOVE INSERTION TOOL (1).

a. Turn handle of insertion tool (1) to

the left until insertion tool can be

removed.

15. INSPECT INSTALLED INSERT (3).

a. Check that threads of insert (3)

are not twisted, cracked, or stripped.

b. Using depth gage, check that

insert (3) is at its correct depth

below surface. See task for correct

depth.

c. If new insert (3) was damaged during

installation, or installation depth is

not correct, go to step 1.

14. REMOVE TANG (2) FROM INSERT (3).

a. Place tang breakoff tool (4) in tapped

hole (5) with installed insert (3). See

task for proper breakoff tool.

b. Push down end of breakoff tool (4)

until tang (2) breaks off of insert (3).

c. If tapped hole (5) is a blind hole,

remove and discard tang.

END OF TASK

2-170