TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 243 of 933

TM 9-2520-270-34

INSTALL

6. PUT NEW INSERT (1) ON

DRIVE WRENCH (2). See task for

proper insert and drive wrench.

8. POSITION NEW LOCKRING (4)

ON INSERT (1).

a. Aline serrations of insert (1) with

serrations of Iockring (4).

7. INSTALL INSERT (1).

a. Coat outside threads of insert (1)

with sealant compound.

b. Using drive wrench (2), screw

insert (1) into housing threads (3). See

task for proper installation depth.

CAUTION

Do not allow drive tool to contact housing.

Any impact of pressure on housing surface

may damage housing threads. Damage to

equipment can ocur.

9. INSTALL NEW LOCKRING (4).

a. Position drive tool (5) in Iockring (4)

on insert (1).

b. Using hammer, strike top of drive

tool (5) until Iockring (4) is in

position. See task for proper

installation depth.

GO TO NEXT PAGE

2-177