TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 249 of 933

TM 9-2520-270-34

CAUTION

Do not remove encased seal unless cover is

properly blocked to prevent bending. Damage

to equipment can occur.

2. REMOVE PLAIN ENCASED SEAL (1).

a. Position cover (2) on three

2- by 4- by 6-inch wood blocks (3).

b. Fit small end of oil seal replacer (4)

into seal (1).

c. Using plastic-faced hammer, tap

seal (1) from cover (2) and discard

seal.

INSTALL

CAUTION

Do not install seal without properly

cover. Damage to cover can occur.

3. POSITION COVER (2).

a. Position cover (2) on one 2-

4- by 6-inch wood block (3)

blocking

by

4. INSTALL NEW SEAL (1).

a. Coat inside of new seal (1) with

transmission oil.

b. Fit large end of oil seal replacer (4)

into new seal (1).

c. Coat outside of seal (1) with sealant

compound. Using plastic-faced

hammer, tap seal into cover (2).

GO TO NEXT PAGE

3-3