TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 252 of 933

TM 9-2520-270-34

I

2. REMOVE FOUR SCREWS (1) AND

LOCK WASHERS (2). DISCARD

LOCK WASHERS.

NOTE

Filter element may be found either on cap or in

hole.

4. REMOVE FLUID FILTER ELEMENT (5).

a. Pull element (5) from cap (3) or

hole (6).

b. Cover hole (6) with clean rag.

5. REMOVE AND DISCARD TWO

PREFORMED PACKINGS (7) AND

HYDRAULIC O-RING (8).

6. CHECK ELEMENT (5) FOR METAL CHIPS.

a.

b.

If chips are found, check main

transmission filter for chips. See task

INSPECT TRANSMISSION FOR

CONTAMINATION, page 4-67.

If no chips are found, go to step 7.

WARNING

Solvent fumes can burn and

could poison you. Read warn-

ing in the front of this

manual.

7. CLEAN ELEMENT (5).

a. Using cleaning solvent, clean

element (5).

REMOVE CAP (3).

a. Using hammer and punch, rotate cap (3)

to the right. Rotate until pry bar can

be placed under a corner (4) of cap.

b. Using pry bar under cap (3), pry up

cap and lift off.

3-6