TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 250 of 933

TM 9-2520-270-34

WARNING

Solvent fumes can burn and

could poison you. Read warn-

ing in the front of this

manual.

5. CLEAN MOUNTING SURFACES (1)

AND (2).

a. Use wiping rag dampened with

cleaning solvent.

7. SECURE COVER (4).

a. Place ring (6), flat side out, on

cover (4).

b. Aline ring (6) with bolt holes and

pins (5).

c. Install 12 new lock washers (7)

and bolts (8).

8. USING 3/8-lNCH DRIVE TORQUE

WRENCH AND 7/16-lNCH

SOCKET, TORQUE 12 BOLTS (8)

TO 75-85 in-lb (86-98 cmkg).

6.

CAUTION

Do not allow lip of seal to catch on shaft.

Seal may leak causing damage to equipment.

POSITION NEW GASKET (3) AND

COVER (4).

a. Apply petrolatum to gasket mounting

surface (1).

b. Aline new gasket (3) with pins (5),

and position on mounting surface (1).

c. Aline cover (4) with pins (5), and

position on mounting surface (1).

END OF TASK

3-4

change 1