TM-9-2520-270-34
HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY
TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE
NOVEMBER 1984
TM-9-2520-270-34 - Page 241 of 933
TM 9-2520-270-34
16. PREPARE OVERSIZE INSERT SWAGE
TOOL (1).
a. See task for proper oversize insert
swage tool (1).
b. See task for proper swage tool stop (2).
c. Install swage tool stop (2) on
swage tool (1).
18. PREPARE STANDARD INSERT
SWAGE TOOL (5).
a.
b.
c.
See task for proper standard insert
swage tool (5).
See task for proper swage tool
stop (6).
Install swage tool stop (6) on swage
tool (5).
17. LOCK INSERT (3) IN PLACE.
a. Put swage tool (1) into insert (3).
b. Using hammer, strike top of swage
tool (1) until swage tool stop (2)
bottoms on housing (4). Remove tool.
c. Inspect new insert (3) for damage
during installation. If damaged, go to
step 1. If not, go to step 20.
19. LOCK INSERT (7) IN PLACE.
a.
b.
c.
Put swage tool (5) into insert (7).
Using hammer, strike top of swage
tool (5) until swage tool stop (6)
bottoms on housing (8). Remove tool.
Inspect new insert (7) for damage
during installation. If damaged, go to
step 1.
20. CLEAN ALL NEW INSERTS AND
RELATED HOUSING.
a. Clean assembly and hardware. See
page 2-2.
END OF SUBTASK
2-175
Back to Top
