TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 246 of 933

TM 9-2520-270-34

washer.

Screw elbow (1) into housing (4) until

captive washer (3) touches housing.

Turn elbow (1) to position needed for

connection to hose assembly (5).

3. INSTALL ELBOW (1).

a. Turn locknut (2) toward captive

washer (3) until locknut touches captive

b.

c.

4.

5.

CAUTION

Do not twist hose assembly when connecting

to elbow. Damage to equipment can occur.

CONNECT HOSE ASSEMBLY (5).

a. Aline cup seat (6) inside swivel nut (7)

with elbow cone (8).

b. Connect and hand tighten hose

assembly (5) to elbow (1).

HOLD ELBOW (1). USING 3/8-lNCH DRIVE

TORQUE WRENCH AND 9/16-INCH

CROWFOOT, TORQUE LOCKNUT (2) TO

125-135 IN-LB (144-155 cmkg).

6.

7.

8.

USING OPEN-END WRENCH, HOLD HOSE

NUT (9).

USING 3/8-INCH DRIVE TORQUE

WRENCH AND 9/16-lNCH CROWFOOT,

TORQUE SWIVEL NUT (7) TO

125-135 IN-LB (144-155 cmkg).

RETORQUE LOCKNUT (2) ON

ELBOW (1).

a.

b.

c.

Loosen locknut (2) on elbow (1) to zero

torque.

Hold elbow (1) from turning.

Torque locknut (2) to 125-135 in-lb

(144-155 cmkg).

END OF TASK

2-180

Change 3