TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 645 of 933

TM 9-2520-270-34

NOTE

Thrust washer can be in carrier.

6. REMOVE THRUST WASHER (1) FROM

SPUR GEARSHAFT (2).

7.

INSPECT THRUST WASHER (1)

FOR DAMAGE. See page 2-5.

a. Replace thrust washer (1) if

damaged.

7.1 REMOVE SPUR GEAR (2.1).

9. PLACE OUTPUT HOUSING (7) ON TWO

WOOD BLOCKS SO THAT CARRIER (8)

IS FREE TO ROTATE.

10. INSTALL OUTPUT HOUSING

INSTALLER (9) INTO SPLINED

OUTPUT SHAFT (10).

4-316

Change 1

8.

REMOVE REMOVAL ASSEMBLY (3).

a. Unscrew two screws (4) and remove

removal assembly (3).

b. Install two lock washers (5) and

screws (6).

11.

12.

USING 3/8-lNCH DRIVE

HINGED HANDLE AND 3/4-lNCH

SOCKET, ROTATE CARRIER (8).

a. If carrier (8) cannot be rotated,

remove output housing installer (9)

and go to step 12. If carrier can be

rotated, remove output housing

installer and go to step 13.

REPAIR LEFT-HAND OUTPUT

HOUSING, page 4-323.