TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 652 of 933

WARNING

Hanging loads could kill or

injure you. Keep away from

hanging loads and overhead

equipment.

31. REPAIRER AND HELPER INSTALL

OUTPUT HOUSING (1).

a.

b.

c.

d.

Lift output housing (1).

Slowly lower output housing

into place. Use four long screws (2)

for alinement, one in each corner.

Do not tighten screws (2).

(H) Use 3/8-inch drive hinged handle

and 3/4-inch socket on output housing

installer (3). Rotate carrier (4) until

output housing (1) drops into place

over pins (5). Remove four screws (2).

(H) Turn output housing installer (3)

one complete turn to be sure output

housing (1) is properly seated.

TM 9-2520-270-34

32. DETACH LIFTING DEVICE (6).

33. REMOVE REMOVAL ASSEMBLY

a. Unscrew two screws (8).

b. Remove removal assembly (7).

34. REMOVE INSTALLER (3).

(7).

35. INSTALL LIFTING EYE (9).

a. Secure eye (9) with two new lock

washers (10) and 4 3/4-inch screws (11).

36. USING 1/2-lNCH DRIVE TORQUE

WRENCH, TORQUE TWO SCREWS (11)

TO 40-45 ft-lb (6 mkg).

GO TO NEXT PAGE

Change 1

4-321