TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 659 of 933

TM 9-2520-270-34

18. REMOVE INNER BRAKE ACTUATING

PLATE (1).

a. Lift out plate (1).

b. Remove and discard special rubber

seal (2).

c. Remove eight bearing balls (3).

19. REMOVE OUTER BRAKE ACTUATING

PLATE (4).

20. REMOVE THRUST WASHER (5).

21. INSPECT TAPERED ROLLER CUP (6).

a. Inspect cup (6) for damage. See

TM 9-214.

b. If cup (6) is damaged, go to step 25.

If not, go to step 22.

22. USING MICROMETER CALlPER SET

AND TELESCOPING GAGE SET,

MEASURE INSIDE DIAMETER OF

SHAFT HOLE (7).

a. If measurement is greater than

1.0017 inches (25.443 mm), go to

step 25. If not, go to step 23.

4-328