TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 662 of 933

TM 9-2520-270-34

NOTE

Rod end connector (7) has left-hand threads.

36. ASSEMBLE ROD END CLEVIS (1)

AND ADJUSTER (2).

a. Install nut (3) on rod end

connector (4).

b. Install rod end connector (4) four

turns into adjuster (2).

c. Aline rod end connector (4) with

clevis (1). Install pin (5) and new

cotter pin (6).

d. Install rod end connector (7) four

turns into adjuster (2).

39. (DELETED)

37. INSTALL CLEVIS (1) AND ADJUSTER (2).

a. Place clevis (1) and adjuster (2)

on plate (8).

b. Coat threads of two screws (9) with

sealant compound.

c. Using 3/8-inch drive brace handle and

1/4-inch socket wrench attachment,

install two screws (9).

38. USING 1/2-lNCH DRIVE TORQUE

WRENCH WITH SOCKET WRENCH

ADAPTER, EXTENSION, AND

1/4-lNCH SOCKET WRENCH ATTACH-

MENT, TORQUE TWO SCREWS (9) TO

20-25 ft-lb (3 mkg).

40. INSTALL INNER BRAKE ACTUATING

PLATE (11).

a. Install eight bearing balls (12) in

eight recesses (13) on outer plate (8).

b. Coat new special rubber seal (14) with

transmission oil.

c. Install seal (14) on inner plate (11).

d. Install inner plate (11) with

recesses (15) facing balls (12). Be

sure plate is firmly seated on balls.

GO TO NEXT PAGE

Change 2

4-331