TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 650 of 933

TM 9-2520-270-34

22.

23.

24.

(DELETED)

INSTALL COVER (1) IF REMOVED.

a. Install new gasket (2) and cover (1).

b. Using 3/8-inch drive brace handle and

7/16-inch socket, install eight new lock

washers (3) and screws (4).

USING 3/8-lNCH DRIVE TORQUE

WRENCH AND 7/16-lNCH SOCKET,

TORQUE EIGHT SCREWS (4) TO

75-85 in-lb (86-98 cmkg).

25. INSTALL OUTPUT HOUSING

INSTALLER (5).

a. Aline splines on installer (5)

splines in carrier (6).

b. Install installer (5).

WARNING

Fixture removal assembly must

be installed in position shown.

Output housing is heavy. Im-

proper installation of removal

assembly can cause an uneven

lift and injury to personnel.

26. INSTALL REMOVAL ASSEMBLY (7).

a. Remove two screws (8) and lock

washers (9). Discard lock washers.

with

b. Put removal assembly (7) on output

carrier (10).

c. Tighten two screws (11).

GO TO NEXT PAGE

Change 1

4-319