TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 220 of 620

TM 9-2520-272-40

0027

REMOVE STEER GEARS

NOTE

It is not necessary to remove bearings during disassembly for inspection. Refer to TM 9-214.

Bearings on underside of right steer driven gear and range steer gear have cages and inner

races. Outer races stay in right cover assembly housing.

Bearings and races staying in the right cover assembly, after gears have been removed in this

task, require heat to be applied for removal. Refer to Repair Right Brake Support Assembly,

WP 0024, for removal of these bearings and races.

1. Remove right steer driven gear (Figure 1, Item 1) and bearing (Figure 1, Item 6) from right output shaft (Figure

1, Item 5).

2. Make sure bearing (Figure 1, Item 6) is serviceable. If bearing requires replacement, remove bearing (Figure 1,

Item 6) from right steer driven gear (Figure 1, Item 1).

3. Remove range steer gear (Figure 1, Item 2) and bearing (Figure 1, Item 3) from right cover assembly (Figure

1, Item 4).

4. Make sure bearing (Figure 1, Item 6) is serviceable. If bearing requires replacement, remove bearing (Figure

1, Item 3) from range steer gear (Figure 1, Item 2).