TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 212 of 620

TM 9-2520-272-40

0026

REMOVE RIGHT BRAKE APPLY CAM SHAFT

NOTE

Right cover assembly on two wooden blocks, inner side turned up.

Right brake apply cam shaft may have come out with right brake support or it may be in right

cover assembly. Tension between right brake apply cam shaft and seal usually causes shaft

to stay in end cover.

Right brake apply cam shaft should come out of the right cover assembly when right brake

apply cam shaft is pulled. If right brake apply cam shaft stays on seal, turn right cover assembly

over and tap on taped end of right brake apply cam shaft.

1. Remove right brake apply cam shaft (Figure 1, Item 4) from right cover assembly (Figure 1, Item 3).

NOTE

Washer may stay with right cover assembly or it may come out with right brake apply cam shaft.

Thrust washer may have stayed with right brake support or it may be on right brake apply

cam shaft.

2. Remove washer (Figure 1, Item 2) from right brake apply cam shaft (Figure 1, Item 4) or right cover assembly

(Figure 1, Item 3).

3. Remove thrust washer (Figure 1, Item 1) from right brake apply cam shaft (Figure 1, Item 4), if present.