TM-9-2520-272-40
CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A
TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL
FEBRUARY 2012
TM-9-2520-272-40 - Page 216 of 620
TM 9-2520-272-40
0026
NOTE
End of brake apply cam shaft opposite splined end goes into right brake support assembly.
13.Install brake apply cam shaft (Figure 4, Item 4) through thrust washer (Figure 4, Item 1) and into needle bearing
(Figure 4, Item 14) so that straight end of spring (Figure 4, Item 6) and cam arm (Figure 4, Item 12) are on
opposite sides of long brake reaction pin (Figure 4, Item 15).
14.Tap end of brake apply cam shaft (Figure 4, Item 4) as necessary to install brake apply cam shaft in right brake
support assembly (Figure 4, Item 13).
15.Clean splined end of brake apply cam shaft (Figure 4, Item 4).
CAUTION
Protective material, such as masking tape, must cover splines when brake apply cam shaft
goes through right cover assembly. If brake apply cam shaft goes through seal without
protection, splines on brake apply cam shaft will damage seal.
16.Wind masking tape over splines and end of brake apply cam shaft (Figure 4, Item 4).
17.Apply petrolatum over tape on brake apply camshaft (Figure 4, Item 4).
0026
‐
6
Back to Top
