TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 227 of 620

TM 9-2520-272-40

0028

2. Turn right cover assembly (Figure 2, Item 5) over, external side up, on two wooden blocks.

3. Remove right output shaft (Figure 2, Item 1), retaining bearing assembly (Figure 2, Item 2), and sleeve (Figure

2, Item 6) from output shaft seal (Figure 2, Item 4) in right cover assembly (Figure 2, Item 5).

4. Refer to TM 9-2350-277-13&P to remove output shaft seal from right cover assembly.

NOTE

When retaining bearing assembly is removed from right output shaft, sleeve is pushed ahead of

retaining bearing assembly.

5. Make sure retaining bearing assembly (Figure 2, Item 2) and sleeve (Figure 2, Item 6) are serviceable. If

retaining bearing assembly or sleeve needs to be replaced, push retaining bearing assembly (Figure 2, Item 2)

and sleeve (Figure 2, Item 6) from right output shaft (Figure 2, Item 1).