TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 235 of 620

TM 9-2520-272-40

0029

NOTE

Bearings are not to be replaced unless defective. Refer to TM 9-214 for inspection of bearings.

When either bearing on gears is defective, both top and bottom bearings on the gear must be

replaced.

When the inner race and rollers are replaced, the outer race must also be replaced.

The outer races for bearings on top of gears remain in the right cover assembly. Refer to

Repair Right Cover Assembly, WP 0017, to replace these races.

Outer races for bearings under gears remain in the center housing assembly. Refer to Repair

Center Housing Components (WP 0043) to replace these races.

3. Remove range output driven gear (Figure 2, Item 6) from transmission (Figure 2, Item 3).

4. Remove range output drive gear (Figure 2, Item 7) from transmission (Figure 2, Item 3).

5. Remove steer shaft drive gear (Figure 2, Item 4) from transmission (Figure 2, Item 3).

NOTE

If bearings require replacement, continue on to Step 6.

If bearings are serviceable, go to the NOTE just before Step 7.

6. Remove two bearings (Figure 2, Item 5) from range output driven gear (Figure 2, Item 6).