TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 238 of 620

TM 9-2520-272-40

0029

NOTE

Do Step 5 and Step 6 only if old bearing was removed.

5. Lubricate bearing (Figure 5, Item 9) journals on both sides of range output drive gear (Figure 5, Item 7) with

lubricating oil and petrolatum.

NOTE

Bearings consist of inner race with rollers and outer races. Make sure that the outer race

beneath the gear is in the left brake support assembly (refer to Repair Left Brake Support,

WP 0046) and outer race above gear is in right cover assembly (refer to Repair Right Cover

Assembly, WP 0017).

6. Install two new bearings (Figure 5, Item 9) on range output drive gear (Figure 5, Item 7). Press bearings

to shoulder.

7. Apply lubricating oil to bearings (Figure 5, Item 9).

8. Install range output drive gear (Figure 5, Item 7) on shaft and bushing assembly (Figure 5, Item 12), with

either side of gear (Figure 5, Item 7) down.