TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 230 of 620

TM 9-2520-272-40

0028

6. Turn right cover assembly (Figure 5, Item 5) over, inside up, on wooden blocks.

7. Apply a thin coat of petrolatum to inner surface of output shaft seal (Figure 5, Item 4).

8. Start short end of right output shaft (Figure 5, Item 1) and retainer bearing assembly (Figure 5, Item 2) into

output shaft seal (Figure 5, Item 4). Turn shaft while pushing end of shaft through seal.

9. Turn right cover assembly over and check that output seal (Figure 5, Item 4) stays in position in right cover

assembly (Figure 5, Item 5), and that lip on seal is not twisted when right output shaft (Figure 5, Item 1)

passes through output shaft seal (Figure 5, Item 4).