TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 239 of 620

TM 9-2520-272-40

0029

NOTE

Do Step 9 and Step 10 only if old bearing was removed.

9. Lubricate bearing (Figure 6, Item 5) journals on both sides of range output driven gear (Figure 6, Item 6) with

lubricating oil and petrolatum.

NOTE

Bearings consist of inner race with rollers and outer races. Make sure that outer race beneath

output driven gear is in left brake support assembly (refer to Repair Left Brake Support,

WP 0046) and outer race above gear is in Right Cover Assembly (refer to Repair Right Cover

Assembly, WP 0017).

10.Install two new bearings (Figure 6, Item 5) on range output driven gear (Figure 6, Item 6). Press bearings

to shoulder.

11. Apply lubricating oil to two bearings (Figure 6, Item 5).

12.Install range output driven gear (Figure 6, Item 6) on steer ring gear assembly (Figure 6, Item 13) (located on

left output shaft), with longer internal spline on gear (Figure 6, Item 6) down.

NOTE

Retaining rings on each end of outer (right) steer shaft serve as stops. It is not necessary to

replace retaining rings that are in good condition.

Outer (right) steer shaft may be installed either end f rst.

13.Install outer (right) steer shaft (Figure 6, Item 2) with retaining rings (Figure 6, Item 1) installed in steer shaft

drive gear (Figure 6, Item 4).