TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 237 of 620

TM 9-2520-272-40

0029

INSTALL BEARINGS, OUTPUT DRIVEN GEAR, STEER SHAFT DRIVE GEAR, RANGE

OUTPUT GEARS, AND OUTER (RIGHT) STEER SHAFT

NOTE

Do Step 1 and Step 2 only if old bearing was removed.

1. Lubricate journal (Figure 4, Item 10) located under steer shaft drive gear (Figure 4, Item 4) with petrolatum

and lubricating oil.

NOTE

Bearing consists of cage and inner race. Make sure that outer race is in left brake support

assembly. Refer to Repair Left Brake Support (WP 0046).

2. Install new bearing (Figure 4, Item 8) on journal (Figure 4, Item 10) of steer shaft drive gear (Figure 4, Item

4). Press bearing to shoulder.

3. Apply lubricating oil to bearing (Figure 4, Item 8).

4. Install steer shaft drive gear (Figure 4, Item 4) on end of inner (left) steer shaft (Figure 4, Item 11) with bearing

side of gear down.