TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 234 of 620

TM 9-2520-272-40

0029

REMOVE OUTER (RIGHT) STEER SHAFT, RANGE OUTPUT GEARS, STEER SHAFT DRIVE

GEAR, OUTPUT DRIVEN GEAR, AND BEARINGS

CAUTION

Do the steps in this procedure to remove the components. Failure to comply will let components

fall out of the transmission when the uncovered right side is turned to point down.

NOTE

The outer (right) steer shaft may come out when the right cover assembly is removed.

If necessary, move the shaft back and forth lightly to remove it.

The retaining rings on the steer shafts are stops. Do not remove them unless they show

damage.

1. Remove outer (right) steer shaft (Figure 1, Item 2) from steer shaft drive gear (Figure 1, Item 4) in transmission

(Figure 1, Item 3).

2. Remove two retaining rings (Figure 1, Item 1) from shaft (Figure 1, Item 2) if you observe such damage as them

being out of round, bent, or if their tension is lost.