TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 242 of 620

TM 9-2520-272-40

0030

REMOVE INNER (LEFT) STEER SHAFT, RANGE OUTPUT GEAR SPACER, AND TUBES

NOTE

It may be necessary to lightly move the steer shaft back and forth to remove it from transmission.

1. Remove the inner (left) steer shaft (Figure 1, Item 1).

2. Remove the two retaining rings (Figure 1, Item 2) if they show damage.

NOTE

Do Step 3 only if sleeve (range output gear spacer) is installed. Early models of the X200-4A

Transmission had a sleeve installed. This sleeve was used when older carrier and shouldered

shaft parts were installed. This sleeve is not installed in later models of the X200-4A

Transmission. Refer to TM 9-2520-272-40P for the current conf guration.

3. Remove the sleeve (Figure 1, Item 4) from the shaft and bushing assembly (Figure 1, Item 3).