TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 287 of 620

TM 9-2520-272-40

0036

INSTALL OIL TRANSFER TUBE SEAL RINGS, RANGE INPUT DRIVE GEAR

BEARING, AND INPUT DRIVEN GEAR RACE

NOTE

Make sure that the left cover assembly is turned so that the inner side points up.

Put left cover assembly on two wooden blocks. Put blocks below the edge of the left cover

assembly on the corner nearest the left output shaft bore.

1. Install new small seal (Figure 2, Item 2) and two new large O-rings (Figure 2, Item 3) on the oil transfer tube

assembly (Figure 2, Item 1).

NOTE

Do Step 2, Step 3, and Step 4 if the bearing and race were removed.

2. Apply petrolatum and lubricating oil to the bores in the left cover assembly (Figure 2, Item 6).