TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 566 of 620

TM 9-2520-272-40

0070

REMOVE SOLENOIDS

CAUTION

Do not remove solenoids from valve assemblies while valve assemblies are installed on the

transmission. Bolts can drop through oil return holes into the transmission, damaging the

transmission. Bolt must be retrieved, even if transmission has to be disassembled.

NOTE

Do not remove solenoids unless replacement is necessary.

For solenoid A, one bolt is 1/4 inch longer than the other bolts. This is to allow for the thickness

of spring retainer.

1. Remove two bolts (Figure 1, Item 6) and (Figure 2, Item 6) from any of four solenoids (Figure 1, Item 1) on main

valve body assembly (Figure 1, Item 5), or remove two bolts (Figure 1, Item 6) and (Figure 2, Item 6) from

solenoid A (Figure 1, Item 2) on the main valve body assembly (Figure 1, Item 5).

2. Remove two bolts (Figure 1, Item 6) and (Figure 2, Item 6) from any of two solenoids (Figure 2, Item 1) on

lockup valve body assembly (Figure 2, Item 7).

3. For solenoid A (Figure 1, Item 2), remove spring retainer (Figure 1, Item 3).

4. Remove any of the seven solenoids (Figure 1, Item 1), if necessary.