TM-9-2540-207-14-P
HEATER, VEHICULAR COMPARTMENT, MODEL: A20
TECHNICAL MANUAL; OPERATOR, FIELD, AND SUSTAINMENT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2007
TM-9-2540-207-14-P - Page 94 of 288
TM 9-2540-207-14&P
5-50
Ignitor Holder
(Continued)
5.7.4.3 Installation
! CAUTION !
Prior to re-installing the Ignitor Holder ensure that the threaded Ignitor Holder
receptacle in the Burner Housing is fully aligned with the large holes in both the
Burner Chamber and the Burner Cartridge.
1.
Apply Nickel anti-seize (Loctite 77164) to the threads of the Ignitor Holder.
2.
Using a 3/4" deep socket install the Ignitor Holder. DO NOT over tighten.
3.
Install Ignitor. Ensure that the Ignitor is firmly installed into the Ignitor Holder.
4.
Install the ignitor hatch, DO NOT over tighten (ref 5.7.4).
5.7.5
Burner Chamber (Applies to all Design Iterations)
Figure 5.7-6
Burner Chamber
Note: If the Ignitor has been removed, coat the threads with
Nickel anti-seize (Loctite 77164) when installing.
Back to Top
