TM-9-2540-207-14-P
HEATER, VEHICULAR COMPARTMENT, MODEL: A20
TECHNICAL MANUAL; OPERATOR, FIELD, AND SUSTAINMENT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2007
TM-9-2540-207-14-P - Page 97 of 288
TM 9-2540-207-14&P
5-53
Burner Chamber (continued)
NOTE: Take great care when handling the Burner Cartridge so as not to
damage the Burner Wicks.
Note: IF the wicks are greater than 50%
deteriorated, replace the entire Burner Cartridge (ref. Figure 5.7-9
Burner
Cartridge).
5.7.5.3 Installation
Note: When REPLACING the Burner Chamber, the Flame Tube MUST be
replaced also.
1.
Apply Nickel anti-seize, Loctite 77164 to the threads on the Ignitor Holder.
2.
Insert the Burner Cartridge into the Burner Chamber, ensuring the two large side holes
in each part line up.
3.
Insert the Burner Cartridge with the Burner Chamber into the Burner Housing and at the
same time screw in the Ignitor Holder ensuring the Ignitor Holder enters the large side
hole in the other two parts.
Note:
The Burner Cartridge is held in place by the Ignitor Holder passing
into the large side hole.
Figure 5.7-8
Burner Cartridge Alignment
4.
Apply Loctite 243 (blue) to the three (3) screws, and using a #2 cross-tip screwdriver
secure the Burner Chamber to the Burner Housing using the three (3) screws.
Back to Top
