TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 108 of 779

Figure 4-47. Disconnecting or connectin g

crankcase breather tube at front of engine .

Disconnect

1. Loosen hose clamps (A) and separate rear in-

termediate crankcase breather tube (B) from breather

tube tee.

2. Move breather tube (B) aside so fuel injection angle

bracket can be removed.

Connect

1. Connect rear intermediate crankcase breather tube

(B) to breather tube tee.

2. Tighten hose clamps (A).

Figure 4-48. Disconnecting or connecting rea r

intermediate crankcase breather tube at tub e

tee-engines prior to relocated crankcas e

breather tube .

4-26

Note.

Screws and lock washers are part o f

injection pum p

assembly and must be re -

installed after the angle bracket has bee n

removed .

Figure 4-49. Removing or installing angle

Disconnect

1. Disconnect fuel inlet hose (A) from adapter.

2. Disconnect oil inlet hose (B) from nipple.

Connect

1. Connect oil inlet hose (B) to nipple.

2. Connect fuel inlet hose (A) to adapter.

Figure 4-50. Disconnecting or connectin g

fuel injection pump oil and fuel inlet hoses .