TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 114 of 779

1. Place a metal rod in one of the injection pump coupler

alinement holes (A) as shown in figure 4-64. Injection

pump coupling must be in a rigid position to remove

nut.

2. Remove plain nut (B) and lock washer.

Note.

The nut, lock washer, and key are par t

of the pump assembly and must be installed on

the pump after the coupler sleeve is removed .

Figure 4-60. Removing fuel injection pum p

diaphragm coupler nut and lock washer .

Figure 4-61. Removing fuel injection pump

splined coupler sleeve and hub .

4-32