TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 142 of 779

Disconnect

1. Remove two cap screws (A) and lock washers at-

taching right rear cylinder head oil drain tube to oil

pan.

2. Separate drain tube from oil pan and remove and

discard gasket (B).

Connect

1. Install new gasket (B) between right rear cylinder

head oil drain tube and oil pan.

2. Install two cap screws (A) and lock washers securing

drain tubes to oil pan.

Figure 4-121. Disconnecting or connectin g

right rear cylinder head oil drain tube .

Disconnect

1. Remove three assembled washer screws (A) and seal

washers attaching oil filler tube to oil pan. Discard seal

washers.

2. Remove and discard filler tube gasket (B).

3. Remove three self-locking nuts (C) attaching oil level

indicator tube to oil pan.

4. Remove and discard indicator tube gasket (D).

Connect

1. Position new oil filler indicator tube gasket (D) on oil

pan.

2. Install three self-locking nuts (C) securing indicator

tube to oil pan.

3. Position new oil filler tube gasket (B) on oil pan.

4. Assemble new seal washers on washer screws (A).

Install assembled washer screws securing filler tube to

oil pan.

Figure 4-122. Disconnecting or connectin g

oil-filler and oil level indicator tube s

from oilpan .

4-6 0