TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 144 of 779

Remove

Install

Remove oil pan sealing thread and clean oil pan mating

Apply a thin coat of gasket cement, Specification MIL-C-

surfaces thoroughly.

10523 (ORD), on the oil pan flange and install sealing

thread.

Figure 4-125. Removing or installing oil pan sealing thread .

Section VIl. REPLACEMENT OF VALVE ROCKER ARMS,

ROCKER

ARMSHAFTS,

AND

VALVE

CLEARANCE

ADJUSTING SCREWS

4-14. General

structions o n

remova l

an d

installatio n

This section contains instructions for th e

procedures. Figure references are listed unde r

replacement of valve rocker arms, rocker ar m

appropriate headings in the table. Instruction s

shafts and valve clearance adjusting screws .

apply to either left or right side of the engine.

Refer to Table 4-6 for illustrations and in -

Table 4-6. Valve Rocker Arms, Rocker Arm Shafts and Valve Clearance

Adjusting Screws

4-62