TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 143 of 779

Figure 4-123

Remove

Support oil pan adequately before removin g

1. Cut locking wire and remove 12 drilled head bolts (A)

remaining two nuts and washers then remove oi l

and flat washers attaching the oil pan to crankshaft

damper and oil filter housing.

pan .

2. Remove 27 of the 28 self-locking nuts (B) and flat

Install

washers attaching oil pan to each side of the crankcase

1. Install 28 self-locking nuts (B) and flat washers

assembly.

securing oil pan to each aide of the crankcase assembly.

Note.

One nut and washer are left installed on

2. Install 12 drilled head bolts (A) and flat washers

securing oil pan to crankshaft damper and oil filter

each side of the oil pan, near the center, t o

housing.

prevent oil pan from falling and being damaged .

Figure 4-124. Removing or installing engine oilpan.

4-61