TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 148 of 779

Remove

1. Lift cover and remove oil level indicator (A).

2. Remove drain hose (B) from retaining brackets.

3. Remove seven cap screws (C) attaching valve and

hose brackets to shroud plate.

4. Remove five cap screws (D) attaching plate to frame.

Install

1. Install five cap screws (D) securing plate to frame.

2. Install seven cap screws (C) securing valve and hose

brackets to shroud plate.

3. Install drain hose (B) on retaining brackets.

4. Install oil level indicator (A)

I and close cover.

Figure 4-134. Removing or installing oil leve l

indicator and oil filler and oil leve l

indicator tube shroud plate bolts-tube s

with splash pan installation .

Remove

1. Raise cover plate (A) until oil drain hose clamp (B) is

accessable.

2. Loosen hose clamp (B) and disconnect oil drain hose

from cover plate.

3. Remove cover plate (A) and remove and discard four

preformed packings (C).

Install

1. Install four new preformed packings (C) and position

cover plate (A) on frame.

2. With cover plate partially raised, connect oil drain

hose to cover plate and tighten hose clamp (B).

3. Position cover plate (A) on frame.

Figure 4-135. Removing or installing oil leve l

indicator and oil filter tube uppe r

cover-with splash pan installation .

Figure 4-136. Oil level indicator tube uppe r

cover plate -relocated oil filler tube

modified installed view .

4-66