TM-9-2815-205-24
6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE
FEBRUARY 2013
TM-9-2815-205-24 - Page 137 of 856
CLEANING
WARNING
Cleaning solvent is TOXIC and flammable. Wear protective goggles and gloves; use only
in a well-ventilated area; avoid contact with skin, eyes, and clothes; and do not breathe
vapors. Keep away from heat or flame. Never smoke when using cleaning solvent. Failure
to comply may result in injury, illness, or death to personnel.
WARNING
Compressed air used for cleaning purposes will not exceed 30 PSI (207 kPa). Use only
with protective equipment (goggles, face shield, gloves, etc.). Failure to comply may result
in injury to personnel.
Clean parts with dry cleaning solvent and dry with compressed air.
END OF TASK
INSPECTION-ACCEPTANCE AND REJECTION CRITERIA
Inspect all parts for damage and excessive wear. Replace as necessary.
END OF TASK
ASSEMBLY
1.
If removed, install nipple (Figure 2, Item 11) in adapter (Figure 2, Item 10). Torque nipple to 70–80 lb-ft
(95–108 N·m).
2.
Lightly coat seal of oil filter spin-on element (Figure 2, Item 9) with clean engine oil.
CAUTION
Do not use mechanical means to tighten spin-on oil filter. Over-tightening will damage seal
and filter.
3.
Place oil filter spin-on element (Figure 2, Item 9) on adapter nipple (Figure 2, Item 11) and tighten by hand
until seal contacts adapter (Figure 2, Item 10). Then turn oil filter element an additional two-thirds revolution.
END OF TASK
TM 9-2815-205-24
0019
0019-3
Back to Top
