TM-9-2815-205-24
6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE
FEBRUARY 2013
TM-9-2815-205-24 - Page 373 of 856
CLEANING
WARNING
Cleaning solvent is TOXIC and flammable. Wear protective goggles and gloves;
use only in a well-ventilated area; avoid contact with skin, eyes, and clothes; and
do not breathe vapors. Keep away from heat or flame. Never smoke when using
cleaning solvent. Failure to comply may result in injury, illness, or death to
personnel.
Compressed air used for cleaning purposes will not exceed 30 PSI (207 kPa). Use
only with protective equipment (goggles, face shield, gloves, etc.). Failure to
comply may result in injury to personnel.
Clean air inlet housing and adapter with cleaning solvent and dry with compressed air.
END OF TASK
INSPECTION-ACCEPTANCE and REJECTION CRITERIA
Inspect parts for wear or damage.
END OF TASK
INSTALLATION
1.
Place new air inlet screen (Figure 1, Item 10) on top of blower (Figure 1, Item 9) with wire side to blower.
2.
Install air inlet housing (Figure 1, Item 11), five flat washers (Figure 1, Item 7), five new lockwashers
(Figure 1, Item 6), short screw (Figure 1, Item 5), two long screws (Figure 1, Item 12), and two mid-sized
screws (Figure 1, Item 8) on blower (Figure 1, Item 9) with inlet opening on left side of engine. Torque
screws to 16–20 lb-ft(22–27 N·m).
3.
Install new gasket (Figure 1, Item 13) and air inlet adapter (Figure 1, Item 1) on air inlet housing
(Figure 1, Item 11) with adapter opening toward rear of engine. Align scribe marks on air inlet housing and
adapter. Install four flat washers (Figure 1, Item 4), four new lockwashers (Figure 1, Item 3), and four screws
(Figure 1, Item 2). Torque screws to 16–20 lb-ft (22–27 N·m).
END OF TASK
TM 9-2815-205-24
0056
0056-3
Back to Top
