TM-9-2815-205-24

6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE

FEBRUARY 2013

TM-9-2815-205-24 - Page 377 of 856

CLEANING

WARNING

Cleaning solvent is TOXIC and flammable. Wear protective goggles and gloves;

use only in a well-ventilated area; avoid contact with skin, eyes, and clothes; and

do not breathe vapors. Keep away from heat or flame. Never smoke when using

cleaning solvent. Failure to comply may result in injury, illness, or death to

personnel.

Compressed air used for cleaning purposes will not exceed 30 PSI (207 kPa). Use

only with protective equipment (goggles, face shield, gloves, etc.). Failure to

comply may result in injury to personnel.

Clean air inlet housing with cleaning solvent and dry with compressed air.

END OF TASK

INSPECTION-ACCEPTANCE and REJECTION CRITERIA

Inspect parts for wear or damage.

END OF TASK

INSTALLATION

NOTE

Angle bracket (Figure 1, Item 2) mounts on right side, third hole from rear of air

inlet housing.

Three air inlet housing screws were removed during removal of fuel line clip and

air pump bracket.

1.

Install new screen (Figure 1, Item 7) (with wire side toward blower), angle bracket (Figure 1, Item 2), air inlet

housing (Figure 1, Item 5), nine new lockwashers (Figure 1, Item 4), and nine screws (Figure 1, Item 3) on

blower (Figure 1, Item 8). Torque screws to 16–20 lb-ft (22–27 N·m).

2.

If removed, install plug (Figure 1, Item 1) and plug (Figure 1, Item 6) in air inlet housing (Figure 1, Item 5).

END OF TASK

TM 9-2815-205-24

0057

0057-3