TM-9-2815-205-24
6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE
FEBRUARY 2013
TM-9-2815-205-24 - Page 386 of 856
REMOVAL
1.
Remove four screws (Figure 1, Item 6), four flat washers (Figure 1, Item 5), blower drive cover
(Figure 1, Item 7), and gasket (Figure 1, Item 8) from blower drive support assembly (Figure 1, Item 11).
Discard gasket.
2.
Remove retaining ring (Figure 1, Item 9) and pull blower drive shaft (Figure 1, Item 10) from blower drive
support assembly (Figure 1, Item 11).
3.
Remove two screws (Figure 1, Item 4) and two copper flat washers (Figure 1, Item 3) fastening blower drive
support assembly (Figure 1, Item 11) to flywheel housing. Pull assembly until splined end of drive shaft
(Figure 1, Item 12) is free from drive plate. Turn assembly slightly so serrated end of governor weight shaft
will pass around governor operating fork (Figure 1, Item 2). Discard copper flat washers.
4.
Remove gasket (Figure 1, Item 13) from flywheel housing (Figure 1, Item 1). Discard gasket.
3
4
5
6
7
8
1
9
10
11
12
13
2
MAINT_165
Figure 1.
Blower Drive Support Removal.
END OF TASK
TM 9-2815-205-24
0060
0060-2
Back to Top
