TM-9-2815-205-24

6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE

FEBRUARY 2013

  TM-9-2815-205-24 - Page 389 of 856

INSPECTION-ACCEPTANCE and REJECTION CRITERIA
1.
Inspect all bearings. Revolve ball bearing slowly by hand and observe rough or tight spots. Replace if this
condition exists. Replace bearings if corroded or pitted.
2.
Inspect gear teeth for evidence of scoring, pitting, burning, or wear.
3.
Examine blower drive support thrust washer for scoring and wear. Thickness of new thrust washer is
0.093 to 0.103 inch (2.36 to 2.62 mm).
4.
Inspect serrations on blower drive shaft and governor weight shaft. If excessive backlash is felt when shaft
is inserted into mating part, install new shaft.
5.
Inspect outside diameter of blower drive gear shaft and mating inside diameter of drive support for scoring
and wear.
6.
Examine weight carrier, weights, and pins. Replace worn parts.
END OF TASK
TM 9-2815-205-24
0060
0060-5


Back to Top