TM-9-2815-205-24
6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE
FEBRUARY 2013
TM-9-2815-205-24 - Page 391 of 856
ASSEMBLY - Continued
f.
Place support under inner race of governor weight shaft bearing (Figure 5, Item 16). Start weight end
of governor weight shaft (Figure 5, Item 12) into bearing. Press shaft until shoulder on shaft contacts
inner race of bearing.
g.
Apply sealing compound to edge of new cup plug (Figure 5, Item 20). Press plug into blower drive
support assembly (Figure 5, Item 11) until flush with support.
h.
Check clearance between fully extended governor weights (Figure 5, Items 24 and 29) and drive gear
(Figure 5, Item 17). Clearance must be greater than 0.100 inch.
17
31
16
18
19
20
29
24
17
21
22
11
12
16
0.100 in.
(2.54 mm)
MAINT_169
Figure 5.
Blower Drive Support Assembly.
END OF TASK
TM 9-2815-205-24
0060
0060-7
Back to Top
