TM-9-2815-205-24

6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE

FEBRUARY 2013

TM-9-2815-205-24 - Page 396 of 856

REMOVAL

1.

Remove seven screw assemblies (Figure 1, Item 1), governor cover (Figure 1, Item 2), and gasket

(Figure 1, Item 3) from governor housing (Figure 1, Item 4). Discard gasket.

2.

Remove two bolts (Figure 1, Item 7), two copper flat washers (Figure 1, Item 8), cover (Figure 1, Item 9),

and gasket (Figure 1, Item 10) from governor housing (Figure 1, Item 4). Discard gasket and copper

flat washers.

NOTE

Keep spring pack assembly together as a unit and do not disassemble.

3.

Using face spanner socket wrench, unscrew packing nut (Figure 1, Item 6) and remove spring pack

assembly (Figure 1, Item 5) from side of governor housing (Figure 1, Item 4).

1

9

8

7

2

3

4

6

10

5

MAINT_171

Figure 1.

Governor Cover and Throttle Rod Removal.

CAUTION

Place clean rag over oil drain holes in cylinder head to prevent cotter pin from

falling into engine.

4.

On right cylinder head, remove cotter pin (Figure 2, Item 12) from pin (Figure 2, Item 14). Remove pin from

lower connecting link (Figure 2, Item 15) on injector control tube lever (Figure 2, Item 13). Discard cotter pin.

5.

Remove locknut (Figure 2, Item 16) and disconnect lower connecting link (Figure 2, Item 15) from upper

connecting link (Figure 2, Item 17). Withdraw lower connecting link. Discard nut.

6.

Remove shoulder pin (Figure 2, Item 11) and upper connecting link (Figure 2, Item 17) from inside governor

housing (Figure 2, Item 4).

TM 9-2815-205-24

0061

0061-2