TM-9-2815-205-24
6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE
FEBRUARY 2013
TM-9-2815-205-24 - Page 388 of 856
DISASSEMBLY - Continued
3.
Governor weight shaft and carrier assembly procedures:
a.
Remove four retaining rings (Figure 3, Item 26) from four weight pins (Figure 3, Item 25).
b.
Drive four weight pins (Figure 3, Item 25) out of carrier assembly (Figure 3, Item 15) by tapping on
punch held against grooved end of pin. Remove two low speed weights (Figure 3, Item 24) and two
high speed weights (Figure 3, Item 29).
c.
Press shaft (Figure 3, Item 12) and governor riser assembly (Figure 3, Item 28) from carrier
(Figure 3, Item 27).
NOTE
Do not remove bearing from riser since it is serviced only as an assembly.
d.
Slide governor riser assembly (Figure 3, Item 28) from shaft (Figure 3, Item 12).
27
26
25
28
15
29
24
26
12
25
MAINT_167
Figure 3.
Governor Weight Shaft Disassembly.
END OF TASK
CLEANING
WARNING
Compressed air used for cleaning purposes will not exceed 30 PSI (207 kPa). Use only
with protective equipment (goggles, face shield, gloves, etc.). Failure to comply may result
in injury to personnel.
Wash all parts in fuel oil and dry them with compressed air.
END OF TASK
TM 9-2815-205-24
0060
0060-4
Back to Top
