TM-9-2815-205-24

6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE

FEBRUARY 2013

TM-9-2815-205-24 - Page 402 of 856

REMOVAL

1.

Loosen two clamps (Figure 1, Item 2) on two left fuel rod hoses (Figure 1, Item 1) and slide two hoses onto

left governor link housing (Figure 1, Item 3). Remove housing, hoses, and clamps from left side.

2.

Loosen two clamps (Figure 1, Item 8) on right fuel rod hose (Figure 1, Item 7). Slide hose onto right fuel rod

cover (Figure 1, Item 9).

3.

Insert punch in flywheel housing hole (Figure 1, Item 11) and drive pin (Figure 1, Item 10) towards blower

and clear of rear engine end plate (Figure 1, Item 12).

NOTE

On model 5063-5299, two blower-to-block bolts and washers were removed during igniter

and air pump assembly removal.

4.

Remove four self-locking bolts (Figure 1, Item 4) and four hardened washers (Figure 1, Item 5) fastening

blower and governor assembly (Figure 1, Item 6) to cylinder block.

WARNING

Never crawl under equipment when performing maintenance unless equipment is securely

blocked. Keep clear of equipment when it is being raised or lowered. Do not allow heavy

components to swing while suspended by lifting device. Exercise caution when working

near a cable or a chain under tension as equipment may drop or shift. Failure to comply

may result in injury to personnel.

5.

Using two 3/8-16 eye bolts and multiple leg sling, lift blower and governor assembly (Figure 1, Item 6)

from engine.

1

2

3

2

1

5

4

6

12

11 10

9

7

8

MAINT_174

Figure 1.

Governor and Blower Mounting Hardware Removal.

TM 9-2815-205-24

0062

0062-2